Walk&Roll®
The Walk&Roll® wheels are used to transform the walker from indoors to outdoors, thanks to its pressure brake. This means that when you press down on the walker, the tread rests on the floor, braking the walker, providing greater control and safety.
The main feature of these wheels is that they have an adjustable pressure brake, which allows the user to adjust the brake pressure to their own taste and needs.
This feature sets Walk&Roll® wheels apart from other similar products.
In addition, they can be adapted to many rollators, as they are compatible with 22, 25 and 30 mm tubes, come with 2 wheels per box and the hardware and tools are included.
Braking wheel kit
Convert your walker to an outdoor rollator
Complete your indoor walker and transform it into an outdoor rollator by adding the IM by TotalCare Walk&Roll wheel kit.
Install the wheel kit, no need for a hole with the new Walk&Roll Plus
The new Walk&Roll Plus allows the installation of the kit on your rollator without the need to drill holes in the leg tubes. Thanks to the two fixing screws and the clamping system developed by TotalCare Europe, it is no longer necessary to use a drill to install them.
Compatible with almost all commercially available rollators
Walk&Rolls are versatile and can be adapted to a wide range of walkers, as they are compatible with 22, 25 and 30 mm tubes. In addition, the spring pressure adjustment allows the installation height to be adjusted according to the specific needs of the mat being used.
Adjustable height and pressure force
The Walk&Roll® braking wheels have an innovative system for adjusting the height and force of the brake pressure. This system consists of a screw with a spring with ‘+’ and ‘-’ symbols to allow the user to adjust the brake pressure.
The higher the spring is set, the less force is needed to activate the brake and the lower the spring is set, the more resistance is applied and the more force is needed to activate the brake. In this way, the user can customise and adapt the rollator to his or her needs.
Everything you need for your walker
Thanks to the different sockets included in the kit, you can adapt it to your rollator.
- 2 castors
- 2 screws (45 mm long)
- 2 nuts (4 mm Allen key)
- 2 thin sockets (for 22 mm tube)
- 2 thick sockets (for 25 mm tube)
- Without sockets (for 30 mm tube)
- User's manual
Assembly instructions
1. Remove the end cap of your walker
2. Place the Walk&Roll® wheel on the walker tube.
3. Place the appropriate 22 mm or 25 mm socket. If the walker tube is 30 mm, it will not be necessary to add the socket.
4. Secure the wheel with the through bolt and nut supplied, using the 5 mm allen key included in the packaging.
If your walker does not have holes in the bottom of the tube, it is necessary to make a hole with a 6 mm drill.
It is important to note that if a hole is required to install the Walk&Roll® wheels on your walker, it should be done by a professional. If you have any doubts about drilling the tube, contact the manufacturer of your walker.
